This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
add_port_mapping_in_nat_router [2012/09/14 22:49] greywizard [Cascaded routers] |
add_port_mapping_in_nat_router [2012/10/09 17:48] greywizard [Manually Configure Port Mapping at Router setup page] |
||
---|---|---|---|
Line 91: | Line 91: | ||
and search for it. | and search for it. | ||
- | OR | ||
- | To manually check whether you have a MODEM or a ROUTER, follow these instructions below: | + | |
+ | Alternatively, | ||
* Click on Start -> Run -> type //cmd// -> press Enter or OK -> type // | * Click on Start -> Run -> type //cmd// -> press Enter or OK -> type // | ||
Line 214: | Line 214: | ||
If that is your case, then you're probably using a topology similar with the one below (the IP addresses used in the figure below are used for exemplification, | If that is your case, then you're probably using a topology similar with the one below (the IP addresses used in the figure below are used for exemplification, | ||
- | {{:network_scheme_01.png|}} | + | {{:network_scheme_02.png|}} |
For the purpose of the following discussion we're going to assume that you use a topology similar to the one above (which is the most common). We'll also assume that both your devices are operating in " | For the purpose of the following discussion we're going to assume that you use a topology similar to the one above (which is the most common). We'll also assume that both your devices are operating in " |